MAX9011 Maxim, MAX9011 Datasheet - Page 5

• Manufacturer Part Number: MAX9011
• Description: The MAX9010/MAX9011/MAX9013 single and MAX9012 dual, high-speed comparators operate from a single 4
• Manufacturer: Maxim

Note 4: Although Common-Mode Input Voltage Range is restricted to -0.2V ≤ V
Note 5: For the MAX9012, Input Offset Voltage is defined as the input voltage(s) required to make the OUT output voltage(s) remain
Note 6: Propagation delay for these high-speed comparators is guaranteed by design because it cannot be accurately measured
Note 7: Differential Propagation Delay, measured either on a single output of the MAX9012/MAX9013 (or between OUT and OUT
Note 8: Latch times are guaranteed by design. Latch setup time (t
(V
-100mV
CC
OUT
3V
IN
0
0
= 5V, C
IN: 50mV/div
OUT: 1V/div
absolute maximum voltage limit, i.e., from -0.3V to (V
logic decision provided that at least one of the two inputs is within the specified common-mode range. If both inputs are outside
the common-mode range, the comparator output state is indeterminate.
stable at 1.4V. For the MAX9013, it is defined as the average of two input offset voltages, measured by forcing first the OUT
output, then the OUT output to 1.4V.
with low levels of input overdrive voltage using automatic test equipment in production. Note that for low overdrive
conditions, V
outputs on the MAX9013) is defined as: ∆t
asserting the latch signal. The hold time (t
stable. Latch propagation delay (t
(see Figure 1).
RESPONSE TO +5mV OVERDRIVE
L
= 15pF, T
_______________________________________________________________________________________
t = 5ns/div
OS
A
is added to the overdrive.
= +25°C, unless otherwise noted.)
SC70, 5ns, Low-Power, Single-Supply,
MAX9010–13 toc01
LPD
+100mV
) is the delay time for the output to respond when the latch enable pin is deasserted
OUT
3V
IN
0
0
H
PD(±)
) is the interval after the latch is asserted in which the input signal must remain
IN: 50mV/div
OUT: 1V/div
RESPONSE TO -5mV OVERDRIVE
= |(t
Precision TTL Comparators
CC
PD+
+ 0.3V), without damage. The comparator will make a correct (and fast)
) - (t
t = 5ns/div
SU
PD-
) is the interval in which the input signal must be stable prior to
Typical Operating Characteristics
)|.
CM
MAX9010–13 toc02
≤ (V
CC
- 1.9V), either or both inputs can go to either
6.0
5.5
5.0
4.5
4.0
3.5
3.0
1
vs. INPUT OVERDRIVE
PROPAGATION DELAY
OVERDRIVE (mV)
10
t
t
PD(+)
PD(-)
100
5