MAX4627 Maxim, MAX4627 Datasheet
MAX4627
Available stocks
Related parts for MAX4627
MAX4627 Summary of contents
Page 1
... The MAX4626/MAX4627/MAX4628 are low-on-resis- tance, low-voltage, single-pole/single-throw (SPST) analog switches that operate from a +1.8V to +5.5V sin- gle supply. The MAX4626 is normally open (NO), and the MAX4627 is normally closed (NC). The MAX4628 is normally open (NO) and has two control inputs. These devices also have fast switching speeds (t max 30ns max) ...
Page 2
... Note 1: Signals on NC, NO, or COM exceeding V+ or GND are clamped by internal diodes. Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS— ...
Page 3
... Positive Supply Current I+ Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in this data sheet. Note 3: SOT-packaged parts are 100% tested at +25°C. Limits across the full temperature range are guaranteed by design and correlation ...
Page 4
Low-Voltage, Single-Supply SPST Analog Switches (T = +25°C, unless otherwise noted.) A ON-RESISTANCE vs. COM VOLTAGE OVER SUPPLY VOLTAGE 3 100mA COM 2 +1. +2.0V CC 1.5 1 +2.3V ...
Page 5
... A TOTAL HARMONIC DISTORTION vs. FREQUENCY 0.1 0.01 0.001 10 100 1k FREQUENCY (Hz) PIN MAX4626 MAX4627 MAX4628 — — 2 — — — 4 _______________________________________________________________________________________ 0.5Ω, Low-Voltage, Single-Supply SPST Analog Switches Typical Operating Characteristics (continued 10k ...
Page 6
... ON (SPST) analog switches that operate from a +1.8V to +5.5V single supply. The MAX4626 is normally open (NO), and the MAX4627 is normally closed (NC). The MAX4628 is normally open (NO) and has two control inputs. When powered from a +5V supply, their 0.5Ω R allows high continuous currents to be switched in a variety of applications ...
Page 7
... COM MAX4626 MAX4627 MAX4628 GND MEASUREMENTS ARE STANDARDIZED AGAINST SHORTS AT IC TERMINALS. OFF-ISOLATION IS MEASURED BETWEEN COM_ AND “OFF” NO_ OR NC_ TERMINAL ON EACH SWITCH. ON-LOSS IS MEASURED BETWEEN COM_ AND “ON” NO_ OR NC_TERMINAL ON EACH SWITCH. SIGNAL DIRECTION THROUGH SWITCH IS REVERSED; WORST VALUES ARE RECORDED. ...
Page 8
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 8 _____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2000 Maxim Integrated Products MAX4626 TRANSISTOR COUNT: 186 MAX4627 MAX4628 INL ...