MAX4514 Maxim, MAX4514 Datasheet
MAX4514
Available stocks
Related parts for MAX4514
MAX4514 Summary of contents
Page 1
... Description The MAX4514/MAX4515 are single-pole/single-throw (SPST), CMOS, low-voltage, single-supply analog switches with very low switch on-resistance. The MAX4514 is normally open (NO). The MAX4515 is nor- mally closed (NC). These CMOS switches can operate continuously with a single supply between +2V and +12V. Each switch can handle rail-to-rail analog signals. The off-leakage cur- rent maximum is only 1nA at +25° ...
Page 2
... SOT23-5 (derate 7.1mW/°C above +70°C) .........571mW 8-Pin CERDIP (derate 8.00mW/°C above +70°C).........640mW Operating Temperature Ranges MAX4514C_ _/MAX4515C_ _ ..............................0°C to +70°C MAX4514E_ _/MAX4515E_ _ ............................-40°C to +85°C MAX4514MJA/MAX4515MJA .........................-55°C to +125°C Storage Temperature Range .............................-65°C to +150°C Lead Temperature (soldering, 10s) .................................+300° ...
Page 3
ELECTRICAL CHARACTERISTICS— +5V Supply (continued +4.5V to +5.5V 2.4V, V INH INL PARAMETER SYMBOL SWITCH DYNAMIC CHARACTERISTICS Charge Injection Q (Note 4) Off Isolation V ISO C NO(OFF Off Capacitance C NC(OFF) ...
Page 4
... Note 3: Leakage parameters are 100% tested at maximum-rated hot operating temperature, and are guaranteed by correlation at +25°C. Note 4: Guaranteed, not production tested. Note 5: SOT packaged parts are 100% tested at +25°C. Limits at maximum and minimum rated temperature are guaranteed by design and correlation limits at +25°C. ...
Page 5
... N.C. No Connection (Not Internally Connected Positive Supply-Voltage Input (Analog and Digital Digital Control Input 3 GND Ground — NO Analog Switch (Normally Open Analog Switch (Normally Cosed) FREQUENCY RESPONSE MAX4514/15- -10 ON LOSS 50 -20 40 - PHASE 10 -50 -60 -10 -70 ...
Page 6
... TTL guaranteed high-level minimum of 2.8V, but still compatible with CMOS outputs. Do not connect the MAX4514/MAX4515’ +3V and then connect the logic-level pins to logic-level signals that operate from +5V supply. Output levels can exceed +3V and violate the absolute maximum ratings, damaging the part and/or external circuits. In 50Ω ...
Page 7
... REF AS 50Ω 50Ω REQUIRED V OUT OUT ON LOSS = 20log V IN Figure 4. NO, NC, and COM Capacitance V+ 50 PEAK 90% 90% V OUT OFF V+ 50 PEAK 90% 90% V OUT 0V t OFF MAX4514 MAX4515 IN COM CAPACITANCE GND t ON 1MHz ANALYZER 7 ...
Page 8
... SPST, CMOS Analog Switches _Ordering Information (continued) PART TEMP. RANGE MAX4514EPA -40°C to +85°C MAX4514ESA -40°C to +85°C MAX4514EUK -40°C to +85°C MAX4514MJA -55°C to +125°C MAX4515CPA 0°C to +70°C MAX4515CSA 0°C to +70°C MAX4515CUK 0°C to +70°C MAX4515C/D 0°C to +70°C MAX4515EPA -40° ...