TSM160128B TEAM SOURCE DISPLAY, TSM160128B Datasheet - Page 13

• Manufacturer Part Number: TSM160128B
• Manufacturer: TEAM SOURCE DISPLAY

Specifications of TSM160128B

• Display Format: 160 x 128
• Control/driver Ic: T6963C
• Outline Dimension(mm): 129.0 x 97.0 x 16.5MAX.
• V.a.(mm): 101.0 x 82.0
• Supply Voltage: 5.0V
• Interface Mode: Parallel
• Moq: 500

12. Reliability test
13. Handling precautions
1. Refrain from strong mechanical shock and forces to the module. It may cause improper operating or
2. The polarizer used on the display surface is easily scratched and damaged. Extreme care should be taken
3. Wipe off water or oil drop immediately If you leave drop for a long time, stain and discoloration may occur.
4. Do not touch pads or pins of interface directly with bare hands. When handling the LCD module, put on a
5. Protect the module from static electricity, it may cause damage to CMOS LSI.
6. To prevent LCD panels from degradation, do not operate or store them exposed directly to sunlight or high
7. If the liquid crystal leaks from the panel it should be kept away from the eyes and mouths. In case of
8. Soldering should be only performed on the I/O terminals within the temperature of 280±20℃ and
9. Supply voltage within the specified voltage limit, the maximum rating, higher voltage cause the shorter
10. Do not input any signals before power is turned on. Do not connect or disconnect the module on the state
High temp. operation
High temp. storage
Low temp. operation
Low temp. storage
Humidity
Thermal shock
Vibration
damage to the module.
when handling. When cleaning the display surface, use soft cloth with a solvent recommended : ethyl
alcohol , isopropyl or hexane) and wipe gently, do not use the following solvents : water, ketone or
aromatics .
soft glover like finger-glover.
temperature/humidity.
contact with skins, wash away thoroughly with soap and water.
soldering time should be less than 4 seconds.
LCD life or damaged.
of Power-ON.
item
Frequency :10~55HZ
Duration : 3times , 3min/time
Amplitude : 0.75mm
0℃(30min)ß à50℃(30min) 10cycles
40℃ 90%RH 24hrs
-20℃ 24hrs
-30℃ 24hrs
80℃ 24hrs
70℃ 24hrs
condition
No abnormity in function
and appearance
criterion
-