IR3086AMTR International Rectifier, IR3086AMTR Datasheet - Page 31

• Manufacturer Part Number: IR3086AMTR
• Description: XPHASE Phase IC with OVP with fault overtemp detect. The IR3086AM Phase IC combined with an IR XPhase TM Control IC provides a full featured and flexible way to implement power solutions for the latest high performance CPUs and ASICs.
• Manufacturer: International Rectifier

Specifications of IR3086AMTR

• Package: 20-Lead MLPQ
• Circuit: X-Phase Phase IC
• Iout (a): 2.5A Gate Driver
• Pbf: PbF Option Available

Solder Resist
 The solder resist should be pulled away from the metal lead lands and center pad by a minimum of 0.06mm.
 The minimum solder resist width is 0.13mm. At the inside corner of the solder resist where the lead land
 Ensure that the solder resist in-between the lead lands and the pad land is ≥ 0.15mm due to the high aspect
 The 4 vias in the land pad should be tented with solder resist 0.4mm diameter, or 0.1mm larger than the
The solder resist mis-alignment is a maximum of 0.05mm and it is recommended that the lead lands are all
Non Solder Mask Defined (NSMD). Therefore, pulling the S/R 0.06mm will always ensure NSMD pads.
groups meet, it is recommended to provide a fillet so a solder resist width of ≥ 0.17mm remains.
ratio of the solder resist strip separating the lead lands from the pad land.
diameter of the via.
Page 31 of 33
IR3086A
2/13/09