TLE 7824G Infineon Technologies, TLE 7824G Datasheet - Page 30

• Manufacturer Part Number: TLE 7824G
• Manufacturer: Infineon Technologies

Specifications of TLE 7824G

• Packages: PG-DSO-28
• Flash: 24.0 kByte
• Frequency (f): 24.0 MHz
• High Side Switch: 1
• High Voltage Monitor Input: 5
• Gpio: 8

12
The SUPPLY Output is intended to be used as Hall Sensor supply. In SBC Active and LIN Receive-Only mode
this output can be switched on and off, respectively via an SPI input bit.
Note: The SUPPLY Output needs to be turned-off prior to entering SBC Stop Mode via SPI command as it will
This output provides an output voltage limitation and is protected against overcurrent and overtemperature. The
protection mechanisms for the low-sides switches also apply for this high-side switch. In case of an overcurrent
shutdown the supply output can be re-activated via SPI command. In order to prevent an unintended shut-down
due to an overcurrent situation when a capacitive load is connected, a specified blanking time after switching-on
has been implemented and is applied directly after activation of this output.
Data Sheet
inherit the “on or off state” from the previous operation mode. In case of entering SBC Sleep Mode it is
turned-off automatically.
Supply Output for Hall Sensor Supply
30
Supply Output for Hall Sensor Supply
Rev. 3.01, 2008-04-15
TLE7824G