BTS 5682E Infineon Technologies, BTS 5682E Datasheet - Page 4

• Manufacturer Part Number: BTS 5682E
• Manufacturer: Infineon Technologies

Specifications of BTS 5682E

• Packages: PG-DSO-36
• Channels: 6.0
• Channel Mix: 3x50mohm+2*130mohm+1*230mohm
• Led Mode: Yes
• Cranking Mode: Yes
• Pwm Engine Integrated: No

Configuration and status diagnosis are done via SPI. An 8 bit serial peripheral interface (SPI) is used. The SPI can
be used in daisy chain configuration.
The device provides a current sense signal per channel that is multiplexed to the diagnosis pin IS. It can be
enabled and disabled via SPI commands. An over load and over temperature flag is provided in the SPI diagnosis
word. A multiplexed switch bypass monitor provides short-circuit to
In order to use the same hardware, channels OUT0, OUT1 and OUT2 can be configured to bulb or LED mode.
Channel 5 is designed to fulfill cranking down to 3.2 V.
The SPOC - BTS5682E provides a fail-safe feature via a limp home input pin.
The power transistors are built by N-channel vertical power MOSFETs with charge pumps. The device is
monolithically integrated in SMART technology.
Protective Functions
•
•
•
•
•
•
•
•
Diagnostic Functions
•
•
•
•
•
•
•
Application Specific Functions
•
•
•
Applications
•
•
•
•
Data Sheet
Reverse battery protection with external components
Short circuit protection
Overload protection
Multi step current limitation
Thermal shutdown with latch and dynamic temperature sensor
Overvoltage protection
Loss of ground protection
Electrostatic discharge protection (ESD)
Multiplexed proportional load current sense signal (IS)
Enable function for current sense signal configurable via SPI
High accuracy of current sense signal at wide load current range
Current sense ratio (
Very fast diagnosis in LED mode (>2% duty cycle at 100 Hz)
Feedback on over temperature and over load via SPI
Multiplexed switch bypass monitor provides short circuit to
Fail-safe activation via LHI pin and control via input pins
Load type configuration via SPI (bulbs or LEDs) for optimized load control
Enhanced relay control at channel 5 providing cranking capability down to 3.2 V
High-side power switch for 12 V grounded loads in automotive applications
Especially designed for standard exterior lighting like tail light, brake light, parking light, license plate light,
indicators and equivalent LEDs
Enhanced relay control supported by cranking capable output
Replaces electromechanical relays, fuses and discrete circuits
k
ILIS
) configurable for LEDs or bulbs
4
V
BB
detection
V
BB
diagnosis.
SPOC - BTS5682E
Rev. 1.0, 2008-01-22
Overview