M25P16 Numonyx, B.V., M25P16 Datasheet - Page 22
![no-image](/images/no-image-200.jpg)
M25P16
Manufacturer Part Number
M25P16
Description
16 Mbit, serial Flash memory, 75 MHz SPI bus interface
Manufacturer
Numonyx, B.V.
Datasheet
1.M25P16.pdf
(55 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M25P16
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
M25P16-VMC6G
Manufacturer:
MICRON
Quantity:
4 300
Part Number:
M25P16-VMC6G
Manufacturer:
MICRON
Quantity:
20 000
Company:
Part Number:
M25P16-VMC6TG
Manufacturer:
JUC
Quantity:
20 000
Part Number:
M25P16-VMC6TG
Manufacturer:
MICRON
Quantity:
20 000
Part Number:
M25P16-VME6G
Manufacturer:
MICRON
Quantity:
20 000
Company:
Part Number:
M25P16-VME6TG
Manufacturer:
NUMONYX
Quantity:
8 000
Company:
Part Number:
M25P16-VMF3PB
Manufacturer:
IDT
Quantity:
42
Company:
Part Number:
M25P16-VMF3TP
Manufacturer:
ST
Quantity:
100 000
Instructions
6.4
6.4.1
6.4.2
6.4.3
22/55
Read Status Register (RDSR)
The Read Status Register (RDSR) instruction allows the Status Register to be read. The
Status Register may be read at any time, even while a Program, Erase or Write Status
Register cycle is in progress. When one of these cycles is in progress, it is recommended to
check the Write In Progress (WIP) bit before sending a new instruction to the device. It is
also possible to read the Status Register continuously, as shown in
Table 6.
The status and control bits of the Status Register are as follows:
WIP bit
The Write In Progress (WIP) bit indicates whether the memory is busy with a Write Status
Register, Program or Erase cycle. When set to ‘1’, such a cycle is in progress, when reset to
‘0’ no such cycle is in progress.
WEL bit
The Write Enable Latch (WEL) bit indicates the status of the internal Write Enable Latch.
When set to ‘1’ the internal Write Enable Latch is set, when set to ‘0’ the internal Write
Enable Latch is reset and no Write Status Register, Program or Erase instruction is
accepted.
BP2, BP1, BP0 bits
The Block Protect (BP2, BP1, BP0) bits are non-volatile. They define the size of the area to
be software protected against Program and Erase instructions. These bits are written with
the Write Status Register (WRSR) instruction. When one or more of the Block Protect (BP2,
BP1, BP0) bits is set to ‘1’, the relevant memory area (as defined in
protected against Page Program (PP) and Sector Erase (SE) instructions. The Block Protect
(BP2, BP1, BP0) bits can be written provided that the Hardware Protected mode has not
been set. The Bulk Erase (BE) instruction is executed if, and only if, all Block Protect (BP2,
BP1, BP0) bits are 0.
Status Register Write Protect
SRWD
b7
Status Register format
0
0
BP2
BP1
Block Protect bits
Write Enable Latch bit
BP0
Figure
Table
WEL
Write In Progress bit
2) becomes
11.
M25P16
WIP
b0