SD186ES/SD186EM Advanced Micro Devices, SD186ES/SD186EM Datasheet - Page 10

• Manufacturer Part Number: SD186ES/SD186EM
• Description: SD186ES/SD186EM Demonstration Board Users Manual
• Manufacturer: Advanced Micro Devices

1-4
5. Invoke the terminal emulation program at 19200 baud, no parity, 8 data bits, and 1
6. Reset the board by depressing and releasing the RESET switch (see location in Figure
7. To display the version of the monitor and the commands available, type ? and press
SD186ES/SD186EM Demonstration Board User’s Manual
stop bit; enable the software flow control (Xon/Xoff), if supported.
2 on page 2-3). The LEDs on the board (CR3-CR10) will again flash in an oscillating
pattern for three seconds, as they did upon power up.
During the three-second period while the LEDs are oscillating, type an a in the
terminal window to ensure that the E86MON software uses the correct baud rate.
When the E86MON software receives an a, it adjusts its baud rate (if necessary) and
displays the welcome message and prompt.
If you type a character other than an a, or type no character at all, the E86MON
software still displays the welcome message and prompt, but may be using an
incorrect baud rate. Depressing and releasing the RESET switch gives you another
opportunity to type an a.
Enter.
For detailed information about using the E86MON software, refer to the E86MON
Software User’s Manual included in your kit.