ATA5760 ATMEL Corporation, ATA5760 Datasheet - Page 29
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
ATA5760
Manufacturer Part Number
ATA5760
Description
Ata5760 Uhf Ask/fsk Receiver
Manufacturer
ATMEL Corporation
Datasheet
1.ATA5760.pdf
(41 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ATA5760N3
Manufacturer:
PHILIPS
Quantity:
4 459
Part Number:
ATA5760N3
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
14. Data Interface
4896C–RKE–04/06
Bit 15 is followed by the equivalent time window t9. During this window, the equivalence
acknowledge pulse t8 (E_Ack) occurs if the just programmed mode word is equivalent to the
mode word that was already stored in that register. E_Ack should be used to verify that the
mode word was correctly transferred to the register. The register must be programmed twice in
that case.
Programming of a register is possible both in sleep-mode and in active-mode of the receiver.
During programming, the LNA, LO, lowpass filter IF-amplifier and the FSK/ASK Manchester
demodulator are disabled.
The programming start pulse t1 initiates the programming of the configuration registers. If bit 1 is
set to ’1’, it represents the OFF command to set the receiver back to polling mode at the same
time. For the length of the programming start pulse t1, the following convention should be
considered:
Programming respectively OFF command is initiated if the receiver is not in reset mode. If the
receiver is in reset mode, programming respectively Off command is not initiated and the reset
marker RM is still present at pin DATA.
This period is generally used to switch the receiver to polling mode or to start the programming
of a register. In reset condition, RM is not cancelled by accident.
Programming respectively OFF command is initiated in any case. The registers OPMODE and
LIMIT are set to the default values. RM is cancelled if present.
This period is used if the connected microcontroller detected RM. If the receiver operates in
default mode, this time period for t1 can generally be used.
Note that the capacitive load at pin DATA is limited.
The data interface (see
be connected via the pull-up resistor R
The applicable pull-up resistor R
selected BR_range (see
Table 14-1.
• t1(min) < t1 < 5632 T
• t1 > 7936
t1(min) is the minimum specified value for the relevant BR_Range
C
C
L
L
100pF
-
1nF
Applicable R
T
Clk
Figure 13-2 on page
Clk
Table
:
pup
BR_range
14-1).
B0
B1
B2
B3
B0
B1
B2
B3
pup
depends on the load capacity C
pup
up to 20V and is short-circuit-protected.
28) is designed for automotive requirements. It can
ATA5760/ATA5761
Applicable R
1.6 k to 470 k
1.6 k to 220 k
1.6 k to 120 k
1.6 k to 5.6 k
1.6 k to 47 k
1.6 k to 22 k
1.6 k to 12 k
1.6 k to 56 k
L
at pin DATA and the
pup
29