EMC1043 Standard Microsystems Corp., EMC1043 Datasheet - Page 22

• Manufacturer Part Number: EMC1043
• Description: 1 Degree C Triple Temperature Sensor With Beta Compensation And Hotter Of Two Zones
• Manufacturer: Standard Microsystems Corp.

Revision 1.44 (04-14-08)
4.6
4.7
0Fh
27h
28h
ADDR
ADDR
One Shot
Conversion
Diode 1 Ideality
Correction Factor
Diode 2 Ideality
Correction Factor
REGISTER
Bit 0 - REC - controls the Resistance Error Correction circuitry
The One Shot Register is an address place holder for the one-shot command. Writing to the address
initiates the command. The data written is not important and is not stored. Reading from the one-shot
registers will always return 00h.
The Ideality Configuration Registers store the ideality correction factor that is applied to each external
diode.
The table below shows the ideality factor settings for the Ideality Configuration registers. Shading
indicates power-up default. All codes that are not listed are reserved and should not be used.
Beta Compensation and Resistance Error Correction automatically correct for most diode ideality
errors, therefore it is not recommended that these settings be updated without consulting SMSC.
One Shot Register - (0Fh)
Ideality Configuration Registers (27h - 28h)
REGISTER
'0' - The Resistance Error Correction circuitry is disabled.
'1' (default) - The Resistance Error Correction circuitry is active and will automatically correct for
up to 100 ohms of series resistance in the diode lines for both External Diode 1 and External Diode
2 channels.
Writing to this register address initiates the one-shot. The data is not
important and is not stored
B7
-
-
B7
Table 4.7 Ideality Configuration Registers
B6
-
-
Table 4.6 One Shot Registers
B6
1°C Triple Temperature Sensor with Beta Compensation and Hotter of Two Zones
DATASHEET
B5
B5
B5
B5
22
B4
B4
B4
B4
B3
B3
B3
B3
B2
B2
B2
B2
B1
B1
B1
B1
B0
B0
B0
B0
SMSC EMC1043
12h
(1.008)
12h
(1.008)
00h
DEFAULT
DEFAULT
Datasheet