LTL102SFK LiteOn Technology Corp., LTL102SFK Datasheet - Page 6

• Manufacturer Part Number: LTL102SFK
• Description: Thru-hole Led Lamps 5mm Round Allngap/gap/gaasp Amber Ltl102sfk
• Manufacturer: LiteOn Technology Corp.

1. Application
2. Storage
3. Cleaning
4. Lead Forming & Assembly
Part No. : LTL102SFK
BNS-OD-C131/A4
The LEDs described here are intended to be used for ordinary electronic equipment (such as office equipment,
communication equipment and household applications).Consult Lite-on’s Sales in advance for information on
applications in which exceptional reliability is required, particularly when the failure or malfunction of the LEDs
may directly jeopardize life or health (such as in aviation, transportation, traffic control equipment, medical and life
support systems and safety devices).
The storage ambient for the LEDs should not exceed 30°C temperature or 70% relative humidity . It is recommended
that LEDs out of their original packaging are used within three months.
For extended storage out of their original packaging, it is recommended that the LEDs be stored in a sealed container
with appropriate desiccant or in a dessicator with nitrogen ambient.
Use alcohol-based cleaning solvents such as isopropyl alcohol to clean the LEDs if necessary.
During lead forming, the leads should be bent at a point at least 3mm from the base of LED lens. Do not use the base
of the leadframe as a fulcrum during forming.
Lead forming must be done before soldering, at normal temperature.
During assembly on PCB, use minimum clinch force possible to avoid excessive mechanical stress.
When soldering, leave a minimum of 2mm clearance from the base of the lens to the soldering point. Dipping the
lens into the solder must be avoided.
Do not apply any external stress to the lead frame during soldering while the LED is at high temperature.
Recommended soldering condition :
5. Soldering
Note.: Excessive soldering temperature and / or time might result in deformation of the LED lens or catastrophic
failure of the LED.
Temperature
Soldering time
Soldering iron
LITE-ON TECHNOLOGY CORPORATOIN
300°C Max.
3 sec. Max.
(one time only)
P r o p e r t y o f L i t e - O n O n l y
CAUTIONS
Pre-heat
Pre-heat time
Solder wave
Soldering time
Wave soldering
100°C Max.
60 sec. Max.
260°C Max.
10 sec. Max.
Page :
6
of
8