STE2002_06 ST Microelectronics, Inc., STE2002_06 Datasheet - Page 21

• Manufacturer Part Number: STE2002_06
• Description: 81 x 128 Single-chip LCD Controller/driver
• Manufacturer: ST Microelectronics, Inc.

STE2002
4
4.1
4.2
Instruction set
Two different instructions formats are provided:
- With D/C set to LOW
commands are sent to the Control circuitry.
- With D/C set to HIGH
the Data RAM is addressed.
Two different instruction set are embedded: the STE2001-like instruction set and the
extended instruction set. To select the STE2001-like instruction set the EXT pad has to be
connected to a logic LOW (connect to VSS). To select the extended instruction the EXT pad
has to be connected to a logic HIGH (connect to VDD1).
The instructions have the syntax summarized in
(extended set).
Reset (RES)
At power-on, all internal registers are configured with the default value. The RAM content is
not defined. A Reset pulse on RES pad (active low) re-initialize the internal registers content
(see
with the host controller is interrupted. After the power-on, the Software Reset instruction can
be used to re-load the reset configuration into the internal registers
The default configurations is: .
- Horizontal addressing (V = 0)
- Normal instruction set (H[1:0] = 0)
- Normal display (MX = MY = 0)
- Display blank (E = D = 0)
- Address counter X[6: 0] = 0 and Y[4: 0] = 0
- Temperature coefficient (TC[1: 0] = 0)
- Bias system (BS[2: 0] = 0)
A MEMORY BLANK instruction can be executed to clear the RAM content.
Power down (PD = 1)
When at Power Down, all LCD outputs are kept at V
V
disconnect V
provided. The RAM contents is not cleared.
LCD
Table 10
generator are OFF (V
LCDOUT
,
Table 11
). The internal Oscillator is in off state. An external clock can be
,
Table 12
LCDOUT
). Applying a reset pulse, every on-going communication
output is discharged to V
- Multiplexing Ratio (M[1:0]=0)
- Frame Rate (FR[1:0]=”75Hz”)
- Power Down (PD = 1)
- Dual Partial Display Disabled (PE=0)
- V
Table 10
OP
SS
=0
(display off). Bias generator and
, (basic-set) and
SS
, and then is possible to
Table 11
Instruction set
21/61