PP1300SA-T Protek Devices, PP1300SA-T Datasheet - Page 5
![no-image](/images/manufacturer_photos/0/5/545/protek_devices_sml.jpg)
PP1300SA-T
Manufacturer Part Number
PP1300SA-T
Description
Thyristor Surge Suppressor
Manufacturer
Protek Devices
Datasheet
1.PP1300SA-T.pdf
(6 pages)
05081.R10 2/07
APPLICATION NOTE
FIGURE 1: UL 1459 & FCC Part 68 - Metallic Protection
The TSS (Thyristor Surge Suppressor) device is located across the
tip-to-ring after a limiting resistor and fuse combination. R
R
tion. Without the resistors, the PP3100SB/SC is recommended.
However, with a resistance value of 7.5 Ohms for tip and ring, the
PP3100SA is recommended. Digital signals may use a lower TSS
device depending upon the total tip to ring voltage range. Selection
of the TSS device, either PPxxxxSA or SB/SC is based upon the
value of the tip and ring resistors. For the National Electric Code
(NEC) article 800, it is recommended that at least one fuse be used
in the tip or ring line for metallic surges. Fuses may be replaced with
a suitable Positive Temperature Coefficient (PTC) automatic
resettable current limiting device.
FIGURE 2 - UL 1459 & FCC Part 68 - Longitudinal Protection
There are two TSS devices, one located from tip-to-ground and one
ring-to-ground. For standard analog signals, the PP3100SA is
recommended with a typical resistor value for tip and ring of 15
Ohms. The PP3100SB/SC is recommended for resistor values of 7.5
Ohms each. The National Electric Code (NEC) article 800 requires
two fuse elements when connecting to ground. Fuses or a suitable
Positive Temperature Coefficient (PTC) automatic resettable current
limiting device may be used. The purpose of this circuit is to limit AC
power current from getting on the ground line causing any safety
hazard.
FIGURE 3 - UL 1459 & FCC Part 68 - Metallic & Longitudinal
Protection
Three equal TSS devices are used in this application for metallic (tip-
to-ring) and longitudinal (tip-to-ground and ring-to-ground) protec-
tion. For analog signals, the PP3100SB/SC is recommended. With a
resistance value of 15 Ohms for the tip and ring resistors, the
PP3100SA may be used. The National Electric Code (NEC) article
800 requires two fuse elements when connecting to ground. Fuses
or a suitable Positive Temperature Coefficient (PTC) automatic
resettable current limiting device may be used. This circuit is
recommended for protection against the Bellcore requirement: First
Level Lightning Surge Tests (Telecommunications Port), document #
GR-1089-CORE.
RING
resistors are optional depending upon the TSS device selec-
TIP
and
5
RING
TIP
RING
TIP
RING
TIP
FIGURE 3 - Metallic & Longitudinal Protection
Fuse
FIGURE 2 - Longitudinal Protection
FIGURE 1 - Metallic Protection
R
R
R
R
Tip
Ring
R
R
Tip
Ring
Tip
Ring
PP0640SA
PP3500SC
www.protekdevices.com
Equipment
Protected
To
Equipment
Protected
To
thru
Equipment
Protected
To