SS22SDP4 Nihon Kaiheiki Industry, SS22SDP4 Datasheet - Page 2

• Manufacturer Part Number: SS22SDP4
• Description: Ultra-miniature Slides
• Manufacturer: Nihon Kaiheiki Industry

General Specifications
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com
Electrical Capacity (Resistive Load)
Other Ratings
Materials & Finishes
Environmental Data
PCB Processing
Standards & Certifications
Operating Temp Range:
Power Level (code 2):
Insulation Resistance:
Logic Level (code 4):
Movable Contactor:
Contact Resistance:
Dielectric Strength:
CSA Certification:
UL Recognition or
Mechanical Life:
Contact Timing:
Electrical Life:
Interior Base:
Upper Case:
Lower Case:
Total Travel:
Soldering:
Terminals:
Vibration:
Humidity:
Cleaning:
Actuator:
Shock:
0.1A @ 30V DC
0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: Find additional explanation of operating range in Supplement section.
20 milliohms maximum for power level; 40 milliohms maximum for logic level
100 megohms minimum @ 500V DC
500V AC minimum 1 minute minimum
10,000 operations minimum
10,000 operations minimum
Shorting (make-before-break)
.079” (2.0mm)
Polyamide
Polyester for 3-On models; polyacetal for all other models
Glass fiber reinforced polyester for 3-On models;
glass fiber reinforced polybutylene terephthalate (thermoplastic) for other models
Phosphor bronze with silver plating (code 2) or
phosphor bronze with gold plating (code 4)
Phenolic resin (thermoset)
Brass with silver plating over copper plating or brass with gold plating
–15°C through +60°C (+5°F through +140°F)
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
50G (490m/s
Wave Soldering: See Profile B in Supplement section.
Manual Solder: See Profile B in Supplement section.
Hand clean locally using alcohol based solution.
The SS series devices have not been tested for UL recognition and CSA certification.
These switches are designed for se in a low-voltage, low-current circuit.
When used as intended in a low-voltage, low-current circuit, the results do not produce
hazardous energy.
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Ultra-Miniature Slides
Series SS
03-07