ATA33 White Electronic Designs Corporation, ATA33 Datasheet - Page 13

• Manufacturer Part Number: ATA33
• Description: Density = 16MB-1GB (2GB) ;; Memory Device = Sandisk Flash ;; Organization = X16/x8 ;; Speed (ns) = 250 ;; Volt = 3/5
• Manufacturer: White Electronic Designs Corporation

PC Card Products
Configuration register specifications
This card supports four Configuration registers for the purpose of the configuration and
observation of this card.
1. Configuration Option register (Address 200H)
This register is used for the configuration of the card configuration status and for the issuing the
soft reset to the card.
bit7
SRESET
Note: initial value: 00H
Name
SRESET
(HOST->)
LevlREQ
(HOST->)
INDEX
(HOST->)
INDEX bit assignment
INDEX bit
5 4 3 2 1 0 Card mode
0 0 0 0 0 0 Memory card
0 0 0 0 0 1 I/O card
0 0 0 0 1 0 I/O card
0 0 0 0 1 1 I/O card
October 2001
bit6
LevlREQ
R/W Function
R/W Setting this bit to "1", places the card in the reset state (Card Hard Reset). This
R/W This bit sets to "0" when pulse mode interrupt is selected, and "1" when level mode
R/W This bit is used to select the operation mode of the card as follows.
operation is equal to Hard Reset, except this bit is not cleared. Then this bit is set to "0",
places the card in the reset state of Hard Reset (This bit is set to "0" by Hard Reset) .
Card configuration status is reset and the card internal initialized operation starts when
Card Hard Reset is executed, so the next access to the card should be the same
sequence as the power on sequence.
interrupt is selected.
When Power on, Card Hard Reset and Soft Reset, this data is "000000" for the purpose
of Memory card interface recognition.
bit5
INDEX
Task File register address
0H to FH, 400H to 7FFH
xx0H to xxFH
1F0H to 1F7H, 3F6H to 3F7H
170H to 177H, 376H to 377H
bit4
13
bit3
bit2
Mapping mode
memory mapped
contiguous I/O mapped
primary I/O mapped
secondary I/O mapped
ATA PCMCIA Card
bit1
bit0
ATA30 Series
ATA33 Series