JF15RP1CE Nihon Kaiheiki Industry, JF15RP1CE Datasheet - Page 2

• Manufacturer Part Number: JF15RP1CE
• Description: Ultra-thin Process Sealed Tactiles
• Manufacturer: Nihon Kaiheiki Industry

General Specifications
Electrical Capacity (Resistive Load)
Other Ratings
Materials & Finishes
Environmental Data
PCB Processing
Standards & Certifications
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com
Operating Temperature Range:
Nominal Operating Force:
Insulation Resistance:
or CSA Certification:
Stationary Contacts:
Contact Resistance:
Dielectric Strength:
Movable Contact:
Mechanical Life:
UL Recognition
Electrical Life:
Total Travel:
Low Level:
Soldering:
Terminals:
Vibration:
Humidity:
Cleaning:
Actuator:
Shock:
Case:
Base:
Seal:
50mA @ 24V DC
50 milliohms maximum
500 megohms minimum @ 250V DC
250V AC minimum for 1 minute minimum
500,000 operations minimum
500,000 operations minimum
3.0N for flush actuator
2.0N for sculptured actuator
Flush Actuators .016” (0.4mm); Sculptured Actuator: .031” (0.8mm)
Polyamide for spot illuminated; polycarbonate for full face
Glass fiber reinforced polyamide
Nitrile butadiene rubber
Glass fiber reinforced polyester
Phosphor bronze with silver plating
Brass with silver plating
Brass with silver plating
–25°C through +70°C (–13°F through +158°F)
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
50G (490m/s
Wave Soldering recommended. See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Automated cleaning. See Cleaning specifications in Supplement section.
Switches should not be operated or have any pressure on the actuators during cleaning.
Full face illuminated models suitable only for bottom board spray wash to avoid contamination
of the 2-layered actuator, which may compromise the aesthetics.
The JF Series tactiles have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Ultra-Thin Process Sealed Tactiles
Series JF
03-07