STK301-220 Sanyo Semiconductor Corporation, STK301-220 Datasheet - Page 7

• Manufacturer Part Number: STK301-220
• Description: 7-band, 2-channel Electronic Equalizer
• Manufacturer: Sanyo Semiconductor Corporation

Data Code
1. Turning on the power initiates a process which transmits no
2. Using DI and CLK in conjunction with LC75821 (or
Things to Note
1. A 1000pF rated capacitor (or higher) should be installed between the current pin and V
2. When the control signal on the microcontroller side onsets faster than STK301-220’s V
3. Since the STK301-220 is equipped with a built-in CMOS LSI, sufficient caution should be extended to damage
4. Refer to the specification sheet for itemized details about the LC7522.
With the STK301-220, few crossover bands exist with an increase in swell during total boost. Pass-band-ripple
(P.B.R.) width at this time is 4 dB with Q set at 3.5 fore and aft.
data (0) for 60 clock cycles (initialization clock). When data
is stopped en route, the remaining data is sent only after the
clock has been initialized.
equivalent) involves the transmission of the maximum
initialization clock to those devices involved.
2 kΩ or more should be placed on the DI and CLK line.
caused by static electricity.
STK301-220
SS
.
DD
, a resistor rated at
No. 4793-7/8