MAX8863SEUK-T Maxim, MAX8863SEUK-T Datasheet - Page 6

• Manufacturer Part Number: MAX8863SEUK-T
• Description: Low-Dropout / 120mA Linear Regulators
• Manufacturer: Maxim

Low-Dropout, 120mA Linear Regulators
The MAX8863/MAX8864 are low-dropout, low-quiescent-
current linear regulators designed primarily for battery-
powered applications. They supply an adjustable 1.25V to
6.5V output or a preselected 2.80V (MAX886_R), 2.84V
(MAX886_S), or 3.15V (MAX886_T) output for load currents
up to 120mA. As illustrated in Figure 1, these devices con-
sist of a 1.25V reference, error amplifier, MOSFET driver, P-
channel pass transistor, Dual Mode™ comparator, and
internal feedback voltage divider.
The 1.25V bandgap reference is connected to the error
amplifier’s inverting input. The error amplifier compares this
reference with the selected feedback voltage and amplifies
the difference. The MOSFET driver reads the error signal
Figure 1. Functional Diagram
6
______________________________________________________________Pin Description
_______________Detailed Description
PIN
_______________________________________________________________________________________
1
2
3
4
5
NAME
SHDN
GND
OUT
SET
IN
* AUTO-DISCHARGE, MAX8864 ONLY
SHDN
GND
MAX8864
MAX8863
IN
Active-Low Shutdown Input. A logic low reduces the supply current to 0.1nA. On the MAX8864, a logic low
also causes the output voltage to discharge to GND. Connect to IN for normal operation.
Ground. This pin also functions as a heatsink. Solder to large pads or the circuit board ground plane to max-
imize thermal dissipation.
Regulator Input. Supply voltage can range from +2.5V to +6.5V. Bypass with 1µF to GND (see Capacitor
Selection and Regulator Stability ).
Regulator Output. Fixed or adjustable from 1.25V to +6.5V. Sources up to 120mA. Bypass with a 1µF, <0.2Ω
typical ESR capacitor to GND.
Feedback Input for Setting the Output Voltage. Connect to GND to set the output voltage to the preset 2.80V
(MAX886_R), 2.84V (MAX886_S), or 3.15V (MAX886_T). Connect to an external resistor divider for
adjustable-output operation.
PROTECTION
REVERSE
BATTERY
SHUTDOWN
THERMAL
SENSOR
LOGIC
1.25V
REF
and applies the appropriate drive to the P-channel pass
transistor. If the feedback voltage is lower than the refer-
ence, the pass-transistor gate is pulled lower, allowing more
current to pass and increasing the output voltage. If the
feedback voltage is too high, the pass-transistor gate is
pulled up, allowing less current to pass to the output.
The output voltage is fed back through either an internal
resistor voltage divider connected to the OUT pin, or an
external resistor network connected to the SET pin. The
Dual Mode comparator examines the SET voltage and
selects the feedback path. If SET is below 60mV, internal
feedback is used and the output voltage is regulated to the
preset output voltage. Additional blocks include a current
limiter, reverse battery protection, thermal sensor, and shut-
down logic.
FUNCTION
ERROR
AMP
DUAL-MODE
COMPARATOR
MOS DRIVER
WITH I
LIMIT
60mV
*
N
P
OUT
SET