STK672-630A-E Sanyo Semicon Device, STK672-630A-E Datasheet - Page 14
![no-image](/images/no-image-200.jpg)
STK672-630A-E
Manufacturer Part Number
STK672-630A-E
Description
2-phase Stepping Motor Driver
Manufacturer
Sanyo Semicon Device
Datasheet
1.STK672-630A-E.pdf
(21 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
STK672-630A-E
Manufacturer:
SANYO/三洋
Quantity:
20 000
www.DataSheet.co.kr
3. Calculating STK672-630A-E HIC Internal Power Loss
The average internal power loss in each excitation mode of the STK672-630A-E can be calculated from the following
formulas.
Each excitation mode
2-phase excitation mode
2PdAVex=(Vsat+Vdf) ×0.5×CLOCK×I OH ×t2+0.5×CLOCK×I OH × (Vsat×t1+Vdf×t3)
1-2 Phase excitation mode
1-2PdAVex=(Vsat+Vdf) ×0.25×CLOCK×I OH ×t2+0.25×CLOCK×I OH × (Vsat×t1+Vdf×t3)
Motor hold mode
HoldPdAVex= (Vsat+Vdf) ×I OH
t1, t2, and t3 represent the waveforms shown in the figure below.
Relationship of CLOCK, t1, t2, and t3 in each excitation mode
For Vsat and Vdf, be sure to substitute values from the graphs of Vsat vs. I OH and Vdf vs. I OH while the set current
value is I OH .
Then, determine whether a heat sink is required by comparing with the graph of ΔTc vs. Pd based on the average HIC
power loss calculated.
When designing a heat sink, refer to the section “Thermal design” found on the next page. The average HIC power
loss, PdAV, described above does not have the avalanche’s loss. To include the avalanche’s loss, be sure to add
Equation (2), “STK672-6** Allowable Avalanche Energy Value” to PdAV above. When using this IC without a fin
always check for temperature increases in the set, because the HIC substrate temperature, Tc, varies due to effects of
convection around the HIC.
2-phase excitation mode: t2= (2/CLOCK) - (t1+t3)
1-2 phase excitation mode: t2= (3/CLOCK) -t1
Vsat: Combined voltage represented by the Ron voltage drop+shunt resistor
Vdf: Combined voltage represented by the MOSFET body diode+shunt resistor
CLOCK: Input CLOCK (CLOCK pin signal frequency)
t1: Time required for the winding current to reach the set current (I OH )
t2: Time in the constant current control (PWM) region
t3: Time from end of phase input signal until inverse current regeneration is complete
t1= (-L/(R+0.33)) In (1-((R+0.33)/V CC ) ×I OH )
t3= (-L/R) In ((V CC +0.33)/(I OH ×R+V CC +0.33))
V CC : Motor supply voltage (V)
L: Motor inductance (H)
R: Motor winding resistance (Ω)
I OH : Motor set output current crest value (A)
Motor COM Current Waveform Model
STK672-630A-E
t1
t2
t3
I OH
0A
No. A1129-14/21
Datasheet pdf - http://www.DataSheet4U.net/