SPC-0602-100 Taipei Multipower Electronics, SPC-0602-100 Datasheet - Page 9

• Manufacturer Part Number: SPC-0602-100
• Manufacturer: Taipei Multipower Electronics

PACKING
Tape and Reel Orientation
NOTE : Top view shown with cover tape removed.
ENVIRONMENTAL PERFORMANCE
STANDARDS :
TAPE SPECIFICATIONS:
REEL SPECIFICATIONS:
ITEM
1
2
3
4
5
6
Carrier Tape Type : Conductive.
Cover Tape Type : Antistatic.
Cover Tape Adhesion to Carrier : 10 - 70 grams.
Diameter (flange) : 13” (330.2mm)
TAPE WIDTH
Thermal Shock
Vibration
Solderability
Operating
Temperature
Humidity
Mechanical
Shock
16mm
TEST
All embossed carrier tape packaging will be accomplished in compliance with latest revision of EIA-481
USER DIRECTION OF FEED
“Taping of surface Mount Components for Automatic Placement”.
One cycle shall consist of:
(1)
(2)
(3)
(4)
Inductance deviation within 3.0% after vibration for 1 hour.
In each of three orientations at sweep vibration (10~50~10Hz) with 1.5mm P-P amplitude.
Solder pot at 230°C 5°C, with kester 1544 solder flux.
5 second 1 second.
-25°C~ +80°C( coil contain heat)
Inductance deviation within 5.0%
After 96 hour in 90~95% relative humidity at 40 2°Cand 1 hour drying under normal condition.
Inductance deviation within 5.0% after drop down with 981m/s
Attitude upon a rubber block method shock testing machine, for 1 time, in each of three orientations.
TAIPEI MULTIPOWER ELECTRONIC CO., LTD.
2ND. FL., 542-7, CHUNG-CHENG ROAD,
HSIN-TIEN CITY, TAIPEI, TAIWAN, R.O.C.
TEL: [phone]
30minutes at temperature -30°C
15 seconds maximum at room ambient.
30 minutes at temperature +85°C
15 seconds maximum at room ambient.
Subject samples to 10 cycles. Test per applicable devices specification after a 4 hours stabilization at room ambient.
REEL
22.4mm
Wetting must occur on a minimum of 90% of the terminations.
WIDTH
FAX: [phone]
CONDITION
LABEL AREA
COMPONENT PITCH
Dip parts into solder pot containing 63/37 molten alloy for
12mm
2
(100G)shock.
UNITS PER REEL
COVER TAPE
EMBOSSED CAVITY
1500
CARRIER TAPE