BHC-AUW Everlight Electronics Co., Ltd., BHC-AUW Datasheet - Page 10

• Manufacturer Part Number: BHC-AUW
• Description: 1.8mm Round Subminiature Chip LED
• Manufacturer: Everlight Electronics Co., Ltd.

4.Soldering Iron
once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering
of each terminal. Be careful because the damage of the product is often started at the time of the hand
solder.
5.Repairing
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
itions
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Everlight Electronics Co., Ltd.
Device No. : DSE-421-
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within
Tucheng, Taipei 236, Taiwan, R.O.C
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date: 31-Aug-2005
Tel: [phone]
Fax: [phone]
http://www.everlight.com
Rev.1
Prepared by: Ashley Kuo
42-21/BHC-AUW/1T
Page: 10 of 10