BHC-AN1P2 Everlight Electronics Co., Ltd., BHC-AN1P2 Datasheet - Page 9

• Manufacturer Part Number: BHC-AN1P2
• Description: Chip Led(0.8mm Herght)
• Manufacturer: Everlight Electronics Co., Ltd.

1. Over-current-proof
2. Storage
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Precautions For Use
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 1 year under 30℃ or less and 60% RH or less.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
Everlight Electronics Co., Ltd.
Device No. : SZDSE-175-B01
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
If unused LEDs remain, it should be stored in moisture proof packages.
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
EVERLIGHT ELECTRONICS CO.,LTD.
Prepared date: 19-Oct-2006
http://www.everlight.com
17-215/BHC-AN1P2/3T
Rev.1
Prepared by: Zhifang Pan
Page: 9 of 10