BHC-YN1P2 Everlight Electronics Co., Ltd., BHC-YN1P2 Datasheet - Page 9

• Manufacturer Part Number: BHC-YN1P2
• Description: Chip LED with Right Angle Lens
• Manufacturer: Everlight Electronics Co., Ltd.

Precautions For Use
1. Over-current-proof
2. Storage
3. Soldering Condition
4. Soldering Iron
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of the
hand solder.
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 60%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
2.6 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Everlight Electronics Co., Ltd.
Device No.: SZDSE-221-B02
Customer must apply resistors for protection, otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
Each terminal is to go to the tip of soldering iron temperature less than350℃ for 3 seconds
EVERLIGHT ELECTRONICS CO.,LTD.
Prepared date: 24-Aug-2005
http://www.everlight.com
Prepared by: Wang Zhiyong
Rev.1
22-21/BHC-YN1P2/2C
Page: 9 of 10