KSC-3000 Kodak, KSC-3000 Datasheet - Page 21

• Manufacturer Part Number: KSC-3000
• Description: Color Processor Firmware Code Providing 24-bit RGB Color Image Data at 1 Megapixel Resolution And 30 Frames/second.
• Manufacturer: Kodak

IMAGE SENSOR SOLUTIONS
21
Output FIFO Status (Register 028)
Default: 0
This register indicates errors that occur due to overflow or underflow conditions within the output FIFO. Once this
type of error is detected during a frame, the remainder of the frame is discarded. The most likely cause of this type
of error is an incorrect setting in the output FIFO control and/or TIG control registers.
ID Register (Register 040)
Default: 4120 (1018h)
This register contains an identification string that describes the version of the FPGA bit file.
SIG Result (Register 041)
Default: 1
This register indicates the current signature contained in the signature analyzer. This register is read-only, and the
signature can only be reset using the SIG control register.
Defect Correction (Registers 060 – 069)
Default: None
A valid entry in the defect map will cause the pixel value at the referenced location to be replaced by the average
value of its nearest neighbors. For a green pixel, a 4-way average is used. For a red or blue pixel, a two-way average
is used.
Invalid entries in the defect map are ignored. An entry is invalid if it appears in the first or last row of the image, or
in the first or last two columns of the image.
K S C - 3 0 0 0 R e v 1 . 0
Figure 5 - Defective Green Pixel
w w w . k o d a k . c o m / g o / i m a g e r s
+
+
-
+
+
5 8 5 - 7 2 2 - 4 3 8 5
E m a i l : i m a g e r s @ k o d a k . c o m
+
Figure 5 - Defective Red or Blue
-
Pixel
+