PIC16C773 Microchip Technology, PIC16C773 Datasheet - Page 22

• Manufacturer Part Number: PIC16C773
• Description: 28/40-Pin/ 8-Bit CMOS Microcontrollers w/ 12-Bit A/D
• Manufacturer: Microchip Technology

PIC16C77X
2.2.2.7
This register contains the CCP2, SSP Bus Collision,
and Low-voltage detect interrupt flag bits.
FIGURE 2-9:
DS30275A-page 22
bit7
bit 7:
bit 6-4: Unimplemented: Read as ’0’
bit 3:
bit 2-1: Unimplemented: Read as ’0’
bit 0:
R/W-0
LVDIF
PIR2 REGISTER
LVDIF: Low-voltage Detect Interrupt Flag bit
1 = The supply voltage has fallen below the specified LVD voltage (must be cleared in software)
0 = The supply voltage is greater than the specified LVD voltage
BCLIF: Bus Collision Interrupt Flag bit
1 = A bus collision has occurred while the SSP module configured in I
(must be cleared in software)
0 = No bus collision occurred
CCP2IF: CCP2 Interrupt Flag bit
Capture Mode
1 = A TMR1 register capture occurred (must be cleared in software)
0 = No TMR1 register capture occurred
Compare Mode
1 = A TMR1 register compare match occurred (must be cleared in software)
0 = No TMR1 register compare match occurred
PWM Mode
Unused
U-0
—
PIR2 REGISTER (ADDRESS 0Dh)
U-0
—
U-0
—
R/W-0
BCLIF
Advance Information
U-0
—
.
Note:
U-0
—
CCP2IF
Interrupt flag bits get set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the global
enable bit, GIE (INTCON<7>). User soft-
ware should ensure the appropriate inter-
rupt flag bits are clear prior to enabling an
interrupt.
R/W-0
bit0
2
C Master was transmitting
R = Readable bit
W = Writable bit
U = Unimplemented bit,
- n = Value at POR reset
1999 Microchip Technology Inc.
read as ‘0’