MD4331-Dxx M-Systems, MD4331-Dxx Datasheet - Page 31

• Manufacturer Part Number: MD4331-Dxx
• Description: Mobile DiskOnChip G3 512Mbit/1Gbit Flash Disk
• Manufacturer: M-Systems

www.DataSheet4U.com
28
The following abbreviations are used: IN - Standard (non-Schmidt) input, ST - Schmidt Trigger input, OD - Open drain output, R8 - Nominal
22K pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
VCC
VCCQ
VSS
RSRVD
Signal
D8,C8,F7,E7,
,F3,D2,E2,F2
C7,C3,D3,E3
See Figure 9
Ball No.
G3,J9,
J6, F4
J5
M
A
Input
Type
-
-
-
-
-
Device core supply. Requires a 10 nF and 0.1 µF capacitor.
I/O power supply. Sets the logic ‘1’ voltage level range of I/O
balls/pins. VCCQ may be either 2.5V to 3.6V or 1.65V to
2.0V.
Requires a 10 nF and 0.1 µF capacitor.
Ground. All VSS pins must be connected.
Reserved. All reserved signals are not connected internally
and must be left floating to guarantee forward compatibility
with future products.
Mechanical. These balls are for mechanical placement, and
are not connected internally.
Alignment. This ball is for device alignment and is not
connected internally.
Data Sheet, Rev. 1.0
Power
Other
Description
Mobile DiskOnChip G3
91-SR-011-05-8L
Signal
Supply
Supply
Supply
Type