R1514 RICOH electronics devices division, R1514 Datasheet - Page 6

• Manufacturer Part Number: R1514
• Description: 150mA VOLTAGE REGULATOR
• Manufacturer: RICOH electronics devices division

www.DataSheet4U.com
6
R1514x
TYPICAL APPLICATION
TECHNICAL NOTES
Phase Compensation
load current would vary. Therefore, without the capacitors, C1 and C2, the output voltage is regulated, however,
for more stable operation, use capacitors as C1 and C2. Especially, if the input line is long and impedance is high,
C1 is necessary. Moreover, if you use rather large C2, transient response will be improved. Recommended value
is in the range from 0.1µF to 10µF. Wiring should be made as short as possible.
GND wiring of mounting on board
of HSOP-6J package must be wired to the GND plane when it is mounted on board.
Thermal Shutdown
+150°C(Typ.), the operation of regulator would stop. After that, when the junction temperature is equal or less
than +125°C(Typ.), the operation of regulator would restart. Unless the cause of rising temperature would
remove, the regulator repeats on and off, and output waveform would be like consecutive pulses.
Chip Enable Circuit
output voltage would be unstable or indefinite, or unexpected current would flow internally.
No.2 pin and No.4 pin of SOT-89-5 package must be wired to the GND plane. No.2 pin, No.4 pin and No.5 pin
Thermal shutdown function is included in the R1514x Series, if the junction temperature is equal or more than
Do not make voltage level of chip enable pin keep floating level, or in between V
When using these ICs, consider the following points:
Phase Compensation of the R1514x Series has been made internally for stable operation even though the
Connect the capacitor, C1 between V
C1
DD
pin and GND pin and C2 between V
V
CE
DD
R1514x
Series
GND
V
OUT
C2
OUT
C1=Ceramic 0.1µF
C2=Ceramic 0.1µF
and GND as close as possible.
CEH
V
OUT
and V
CEL
. Otherwise, the