ST20-JPI ST Microelectronics, ST20-JPI Datasheet - Page 5

• Manufacturer Part Number: ST20-JPI
• Description: PC PARALLEL PORT TO JTAG INTERFACE
• Manufacturer: ST Microelectronics

2.2
The ST20-JPI can also be attached to the Ethernet via a B300. To install the hardware connecting
to a B300, the following steps should be followed:
2.3
For installation of the DLL and VxD drivers, please refer to the ST20 Toolset software installation
documentation.
•
•
•
•
•
•
•
Hardware Installation - B300
Connect the B300 to the ST20-JPI using a Differential OS-Link cable supplied with the
B300.
Plug the target development system into the 20-way IDC connector using a 20 way IDC
cable.
Plug power supply cable into PSU socket of the interface.
Plug the power supply into the mains socket.
Switch on the B300.
Switch on the power supply to the ST20-JPI. The LEDs on the interface should illuminate
once the software is running. For a description of the meaning of the LEDs, see the ST20
toolset documentation.
Switch on the Target power supply.
Software Installation
ST20-JPI
5/10