MCP23008 Microchip Technology, MCP23008 Datasheet - Page 12

• Manufacturer Part Number: MCP23008
• Description: 8-Bit I/O Expander with Serial Interface
• Manufacturer: Microchip Technology

MCP23008/MCP23S08
1.6.3
The GPINTEN register controls the interrupt-on-
change feature for each pin.
If a bit is set, the corresponding pin is enabled for
interrupt-on-change. The DEFVAL and INTCON
registers must also be configured if any pins are
enabled for interrupt-on-change.
REGISTER 1-3:
DS21919D-page 12
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 7-0
GPINT7
R/W-0
INTERRUPT-ON-CHANGE
CONTROL (GPINTEN) REGISTER
GPINT7:GPINT0: General purpose I/O interrupt-on-change bits <7:0>
1 = Enable GPIO input pin for interrupt-on-change event.
0 = Disable GPIO input pin for interrupt-on-change event.
Refer to INTCON and GPINTEN.
GPINT6
R/W-0
GPINTEN – INTERRUPT-ON-CHANGE PINS (ADDR 0x02)
W = Writable bit
‘1’ = Bit is set
GPINT5
R/W-0
GPINT4
R/W-0
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
GPINT3
R/W-0
GPINT2
R/W-0
© 2007 Microchip Technology Inc.
x = Bit is unknown
GPINT1
R/W-0
GPINT0
R/W-0
bit 0