LM4877 National Semiconductor, LM4877 Datasheet - Page 13

• Manufacturer Part Number: LM4877
• Description: 1 Watt Audio Power Amplifier in micro SMD package with Shutdown Logic Low
• Manufacturer: National Semiconductor

Application Information
REFERENCE DESIGN BOARD and PCB LAYOUT
GUIDELINES
PCB Layout Guidelines
This section provides practical guidelines for mixed signal
PCB layout that involves various digital/analog power and
ground traces. Designers should note that these are only
depend heavily on the final layout.
General Mixed Signal Layout Recommendation
Power and Ground Circuits
For 2 layer mixed signal design, it is important to isolate the
digital power and ground trace paths from the analog power
and ground trace paths. Star trace routing techniques (bring-
ing individual traces back to a central point rather than daisy
chaining traces together in a serial manner) can have a ma-
jor impact on low level signal performance. Star trace routing
refers to using individual traces to feed power and ground to
each circuit or even device. This technique will take require
a greater amount of design time but will not increase the final
price of the board. The only extra parts required will be some
jumpers.
rule-of-thumb recommendations and the actual results will
(Continued)
Figure 4
13
Single-Point Power / Ground Connections
The analog power traces should be connected to the digital
traces through a single point (link). A Pi-filter can be helpful
in minimizing High Frequency noise coupling between the
analog and digital sections. It is further recommended to put
digital and analog power traces over the corresponding digi-
tal and analog ground traces to minimize noise coupling.
Placement of Digital and Analog Components
All digital components and high-speed digital signals traces
should be located as far away as possible from the analog
components and the analog circuit traces.
Avoiding Typical Design / Layout Problems
Avoid ground loops or running digital and analog traces par-
allel to each other (side-by-side) on the same PCB layer.
When traces must cross over each other do it at 90 degrees.
Running digital and analog traces at 90 degrees to each
other from the top to the bottom side as much as possible will
minimize capacitive noise coupling and cross talk.
DS101290-25
www.national.com