MAS9181B ETC, MAS9181B Datasheet - Page 6

no-image

MAS9181B

Manufacturer Part Number
MAS9181B
Description
OCTAL 8 BIT TRIMMER IC
Manufacturer
ETC
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MAS9181BN
Manufacturer:
MICRONAS
Quantity:
664
Part Number:
MAS9181BN
Quantity:
6 219
Valid addresses are 40, 42, 44, 46, 48, 4A, 4C, 4E(hex),
depending on the programming of bits A2, A1 and A0.
With these addresses, up to eight MAS9181 ICs can be
operated independently from one I
addresses are acknowledged by the MAS9181. The
Valid instructions from 00 to 0F and F0 to FF (hex);
MAS9181 will not respond to other instruction value, but
will still generate an acknowledgement. Instructions 00
to0F cause auto-incrementing of the sub-address (bits
SD to SA) when more than one data byte is sent within
one transmission. With auto-incrementing, the first data
byte is written into the DAC addessed by bits SD to SA
and then the sub-address is automatically incremented
by one position for the next databyte in the series. Auto-
Input SCL (pin 4) and input/output SDA (pin 3) conform
to I
against voltage pulses by internal zener diodes
Input Vmax (pin 2) provides a means of comprising the
output voltage swing of the DACs. The maximum DAC
output voltage is restricted to approximately Vmax while
2
C-bus specifications. Pins 3 and 4 are protected
2
C-bus. No other
address inputs A0, A1 and A2 are programmed by
connection to GND for An = 0 or to VDD for An = 1. If
the inputs are left floating, An = 1 will result. For
MAS9181CS, A2 is always 1.
incrementing does not occur with instructions F0 to FF.
The DAC addressed by the sub-address will always
receive the data if more than one data byte is sent.
Valid sub-addresses (bits SD to SA) are 0 to 7 (hex)
relating numerically to DAC0 to DAC7. When the auto-
incrementing function is used, the sub-address will
sequence through all possible values (0 to F, 0 to F,
etc.). While the sub-address is between 8 and F no
DAC outputs change.
connected to the ground plane and therefore the normal
bus line voltage shall not exceed 5.5V.
the 8-bit resolution is maintained, therefore giving a
finer voltage resolution of smaller output swings.
13 October, 1999
DA9181.006
6

Related parts for MAS9181B