RF6100-4 RF Micro Devices, RF6100-4 Datasheet - Page 4

• Manufacturer Part Number: RF6100-4
• Description: LINEAR POWER AMPLIFIER MODULE
• Manufacturer: RF Micro Devices

2-4
Base
Pkg
Pin
10
RF6100-4
1
2
3
4
5
6
7
8
9
Function
RF OUT
VMODE
VREG
VCC1
VCC2
RF IN
GND
GND
GND
GND
GND
Description
First stage collector supply. A low frequency decoupling capacitor
(e.g., 4.7µF) may be required.
RF input internally matched to 50Ω. This input is internally AC-coupled.
Ground connection. Connect to package base ground. For best perfor-
mance, keep traces physically short and connect immediately to
ground plane.
For nominal operation (High Power Mode), V
set HIGH, devices are biased lower to improve efficiency.
Regulated voltage supply for amplifier bias. In Power Down mode, both
V
Ground connection. Connect to package base ground. For best perfor-
mance, keep traces physically short and connect immediately to
ground plane.
Ground connection. Connect to package base ground. For best perfor-
mance, keep traces physically short and connect immediately to
ground plane.
RF Output internally matched to 50Ω. This output is internally
AC-coupled.
Ground connection. Connect to package base ground. For best perfor-
mance, keep traces physically short and connect immediately to
ground plane.
Output stage collector supply. A low frequency decoupling capacitor
(e.g., 4.7µF) is required.
Ground connection. The backside of the package should be soldered to
a top side ground pad which is connected to the ground plane with mul-
tiple vias. The pad should have a short thermal path to the ground
plane.
REG
and V
MODE
need to be LOW (<0.5V).
MODE
is set LOW. When
Interface Schematic
Rev A0 031217