B150PG01 AU, B150PG01 Datasheet - Page 12

• Manufacturer Part Number: B150PG01
• Description: TFT LCD Module
• Manufacturer: AU

www.DataSheet4U.com
(C) Copyright AU Optronics, Inc.
August, 2001 All Rights Reserved.
No Reproduction and Redistribution Allowed.
RED5
RED4
RED3
RED2
RED1
RED0
GREEN 5
GREEN 4
GREEN 3
GREEN 2
GREEN 1
GREEN 0
BLUE 5
BLUE 4
BLUE 3
BLUE 2
BLUE 1
BLUE 0
DTCLK
DSPTMG
VSYNC
HSYNC
Input signals shall be low or Hi-Z state when VDD is off.
It is recommended to refer the specifications of SN75LVDS86DGG(Texas Instruments) in
detail.
Signal electrical characteristics are as follows;
Note: Output signals from any system shall be low or Hi-Z state when VDD is off.
5.4 Signal Electrical Characteristics
Signal Name
Display Timing
Red Data 5 (MSB)
Red Data 4
Red Data 3
Red Data 2
Red Data 1
Red Data 0 (LSB)
Red-pixel Data
Green Data 5 (MSB)
Green Data 4
Green Data 3
Green Data 2
Green Data 1
Green Data 0 (LSB)
Green-pixel Data
Blue Data 5 (MSB)
Blue Data 4
Blue Data 3
Blue Data 2
Blue Data 1
Blue Data 0 (LSB)
Blue-pixel Data
Data Clock
Vertical Sync
Horizontal Sync
Description
Red-pixel Data
Each red pixel's brightness data consists of
these 6 bits pixel data.
Green-pixel Data
Each green pixel's brightness data consists of
these 6 bits pixel data.
Blue-pixel Data
Each blue pixel's brightness data consists of
these 6 bits pixel data.
The typical frequency is 54.0 MHZ.. The signal
is used to strobe the pixel data and DSPTMG
signals. All pixel data shall be valid at the falling
edge when the DSPTMG signal is high.
This signal is strobed at the falling edge of
DTCLK. When the signal is high, the pixel data
shall be valid to be displayed.
The signal is synchronized to DTCLK .
The signal is synchronized to DTCLK .
B150PG01 Ver. 04
12/12