CEM-120150 CUI, Inc., CEM-120150 Datasheet - Page 3

• Manufacturer Part Number: CEM-120150
• Description: Magnetic buzzer
• Manufacturer: CUI, Inc.

Mechanical Characteristics
Item
Solderability
Soldering Heat Resistance
Terminal Mechanical Strength
Vibration
Drop Test
Environment Test
Item
High temp. test
Low temp. test
Thermal shock
Temp./Humidity cycle
Phone: [phone]
Fax: [phone]
Test Condition
Lead terminals are immersed in rosin for 5
seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Lead terminals are immersed up to 1.5mm from
the buzzer’s body in solder bath of 260 ±5°C for
3 ±1 seconds.
Apply force of 9.8 N (1.0 kg) in each axial
direction for 10 seconds.
The buzzer will be measured after applying
a vibration amplitude of 1.52 mm (9.3G) with 10
to 55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part is to be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axis (X, Y, Z) for a total of 9 drops.
Test Condition
The part will be subjected to +70°C for
96 hours.
The part will be subjected to -30°C for
96 hours
The part will be subjected to 10 cycles. One
cycle will consist of:
The part shall be subjected to 10 cycles. One
cycle will consist of:
Part No: CEM-1201(50)
Description: magnetic buzzer
www.cui.com
20050 SW 112th Ave.
Evaluation Standard
Evaluation Standard
90% surface of lead terminals
should be wet with solder.
(Except the edge of the terminal)
No in interference in operation.
No damage or cutting off.
After the test, the part should
meet specifications without any
damage to the appearance and
the SPL should be within ±10dBA
when compared to the initial SPL.
After the test, the part should
meet specifications without any
damage to the appearance and
the SPL should be within ±10dBA
when compared to the initial SPL.
Tualatin, OR 97062
Date: 8/11/2006
Unit: mm
Page No: 3 of 5