MIC4426 Micrel Semiconductor, MIC4426 Datasheet - Page 6

• Manufacturer Part Number: MIC4426
• Description: Dual 1.5A-Peak Low-Side MOSFET Driver
• Manufacturer: Micrel Semiconductor

MIC4426/4427/4428
Applications Information
Supply Bypassing
Large currents are required to charge and discharge large
capacitive loads quickly. For example, changing a 1000pF
load by 16V in 25ns requires 0.8A from the supply input.
To guarantee low supply impedance over a wide frequency
range, parallel capacitors are recommended for power sup-
ply bypassing. Low-inductance ceramic MLC capacitors with
short lead lengths (< 0.5") should be used. A 1.0 F film
capacitor in parallel with one or two 0.1 F ceramic MLC
capacitors normally provides adequate bypassing.
Grounding
When using the inverting drivers in the MIC4426 or MIC4428,
individual ground returns for the input and output circuits or a
ground plane are recommended for optimum switching speed.
The voltage drop that occurs between the driver’s ground and
the input signal ground, during normal high-current switching,
will behave as negative feedback and degrade switching
speed.
Control Input
Unused driver inputs must be connected to logic high (which
can be V
(< 500 A) , connect unused inputs to ground. A logic-high
signal will cause the driver to draw up to 9mA.
The drivers are designed with 100mV of control input hyster-
esis. This provides clean transitions and minimizes output
stage current spikes when changing states. The control input
voltage threshold is approximately 1.5V. The control input
recognizes 1.5V up to V
1 A within this range.
The MIC4426/7/8 drives the TL494, SG1526/7, MIC38C42,
TSC170 and similar switch-mode power supply integrated
circuits.
MIC4426/4427/4428
S
) or ground. For the lowest quiescent current
S
as a logic high and draws less than
6
Power Dissipation
Power dissipation should be calculated to make sure that the
driver is not operated beyond its thermal ratings. Quiescent
power dissipation is negligible. A practical value for total
power dissipation is the sum of the dissipation caused by the
load and the transition power dissipation (P
Load Dissipation
Power dissipation caused by continuous load current (when
driving a resistive load) through the driver’s output resistance
is:
For capacitive loads, the dissipation in the driver is:
Transition Dissipation
In applications switching at a high frequency, transition power
dissipation can be significant. This occurs during switching
transitions when the P-channel and N-channel output FETs
are both conducting for the brief moment when one is turning
on and the other is turning off.
Charge (Q) is read from the following graph:
P
P
P
L
L
T
= I
= f C
= 2 f V
Crossover Energy Loss per Transition
L
2
L
R
1 10
8 10
6 10
4 10
3 10
2 10
1 10
V
S
O
S
Q
-8
-9
-9
-9
-9
-9
-9
2
4
6
SUPPLY VOLTAGE (V)
8
10
12
14
16
September 1999
L
+ P
18
T
).
Micrel