USB2512A Standard Microsystems Corp., USB2512A Datasheet - Page 10

• Manufacturer Part Number: USB2512A
• Description: Usb2512a Usb 2.0 High-speed 2-port Hub Controller
• Manufacturer: Standard Microsystems Corp.

Revision 1.96 (07-11-08)
LOCAL_PWR/
NON_REM0
SUSP_IND/
RESET_N
SYMBOL
XTAL2
TEST
QFN-36
EMB
32
26
28
11
Table 3.1 USB2512A Pin Descriptions (continued)
BUFFER
OCLKx
TYPE
IPD
I/O
IS
DATASHEET
Crystal Output
24MHz Crystal
This is the other terminal of the crystal, or a NO CONNECT
when an external clock source is used to drive XTAL1/CLKIN.
Note:
RESET Input
The system can reset the chip by driving this input low. The
minimum active low pulse is 1 us.
When the RESET_N pin is pulled to VDD33, the internal POR
(Power on Reset) is enabled and no external reset circuitry is
required. The internal POR holds the internal logic in reset until
the power supplies are stable.
Active/Suspend status LED or Local-Power & Non-removable
Strap Option
Suspend Indicator: Indicates USB state of the hub.
‘negated’ = Unconfigured, or configured and in USB Suspend
‘asserted’ = Hub is configured, and is active (i.e., not in
suspend)
Local Power: Detects availability of local self-power source.
Low = Self/local power source is NOT available (i.e., Hub gets
all power from Upstream USB VBus).
High = Self/local power source is available.
NON_REM0 Strap Option:
If this strap is enabled by package and configuration settings
(see
NON_REM1) at RESET_N negation to determine if ports [2:1]
contain permanently attached (non-removable) devices. Also,
the active state of the LED
will be determined as follows:
NON_REM[1:0] = ‘00’, All ports are removable, and the LED is
active high
NON_REM[1:0] = ‘01’, Port 1 is non-removable, and the LED
is active low
NON_REM[1:0] = ‘10’, Ports 1 & 2 are non-removable, and the
LED is active high
NON_REM[1:0] = ‘11’, Ports 1 & 2 are non-removable, and the
LED is active low
TEST pin
XNOR continuity tests all signal pins on the hub. Please contact
your SMSC representative for a detailed description of how this
test mode is enabled and utilized.
Table
10
This output must not be used to drive any external
circuitry other than the crystal circuit.
3.2), this pin will be sampled (in conjunction with
DESCRIPTION
USB 2.0 Hi-Speed 2-Port Hub Controller
SMSC USB2512A
Datasheet