BHC-ZL1M2RY Everlight Electronic Co., Ltd., BHC-ZL1M2RY Datasheet - Page 10

• Manufacturer Part Number: BHC-ZL1M2RY
• Description: chip LED(0.4mm Height)
• Manufacturer: Everlight Electronic Co., Ltd.

4. Soldering Iron
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
Everlight Electronics Co., Ltd.
Device No:SZDSE-197-B07
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
Tucheng, Taipei 236, Taiwan, R.O.C
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date: 26-Oct-2005
Tel: [phone]
http://www.everlight.com
Fax: [phone]
19-217/BHC-ZL1M2RY/3T
Rev 1
Prepared by:Zhang huali
Page: 10 of 10