CLAA102NA01CW CHUNGHWA PICTURE TUBES, CLAA102NA01CW Datasheet - Page 6

• Manufacturer Part Number: CLAA102NA01CW
• Description: Display Module
• Manufacturer: CHUNGHWA PICTURE TUBES

www.DataSheet.co.kr
CPT
CHUNGHWA PICTURE TUBES, LTD.,
Control signal:High(+3.3V)→Low(GND)
Supply Voltage of rising time should be from R3 and C2 tune to 550 us.
VIN
0.9VIN
0.1VIN
GND
550μs
Rising Time
【Note 4】
Table of specifications are definition of single lamp .
【Note 5】
The frequency is operated in the range, will not influence the life of lamp and display characteristic.
Note 6】
The time needed to start discharge when the over Starting Lamp Voltage is continuously applied to both
ends of the lamp. Before testing, the lamp is left in the dark room (ambient temperature : 25±2℃, ambient
illuminance : less than 0.1lux) for 24Hr after lighted for 1 minute at rated lamp current. The testing shall be
conducted in the dark room. And the sealing side shall be connected to high voltage side. (ambient
temperature :25±2℃, ambient illuminance : less than 0.1lux). The minimum safety time for the inverter need
over the maximum time for the start discharge .
6/18
SPEC_CLAA102NA01CW_V0.4_RB_080612
CPT Confidential
Datasheet pdf - http://www.DataSheet4U.net/