IRM-H240/TR2 Everlight, IRM-H240/TR2 Datasheet - Page 9

• Manufacturer Part Number: IRM-H240/TR2
• Description: (IRM-H2xx/TR2) Infrared Remote-control Receiver Module
• Manufacturer: Everlight

Recommended method of storage
moisture absorption. The following conditions should be observed, if dry boxes are not available:
Reflow soldering:
under the following condition:
ESD Precaution
the devices especially when they are removed from the Anti-static bag. Electro-Static Sensitive
Devices warning labels are on the packing.
Recommended Solder Profile
Notice:
Everlight Electronics Co., Ltd.
Device No：DMO-238-377
(1) Reflow soldering should not be done more than two times.
(2) When soldering, do not put stress on the IRM-H2xx Series devices during heating.
(3) After soldering, do not warp the circuit board.
1~5°C/sec.
After more than 72 hours under these conditions moisture content will be too high for
In case of moisture absorption, the devices will recover to former condition by drying
Proper storage and handing procedures should be followed to prevent ESD damage to
Dry box storage is recommended as soon as the aluminum bag has been opened prevent
192 hours at 40℃+5℃/-0℃ and 5%RH (dry air / nitrogen) or
96 hours at 60℃+5℃ and < 5%RH for all device containers or
24 hours at 125℃+5℃ not suitable for reel or tubes.
Storage temperature 10℃ to 30℃
Storage humidity ≦60%RH max.
120sec.Max.
180~200°C
Pre-heating
1~5°C/sec
EVERLIGHT ELECTRONICS CO.,LTD.
60sec. Max.
Above. 220°C
Prepared date：11-24-2006
http:\\www.everlight.com
10sec Max.
260°C Max.
www.DataSheet.co.kr
IRM-H2xx/TR2 SERIES
Rev 2
Prepared by：Cindy Lin
Page: 9 of 12
Datasheet pdf - http://www.DataSheet4U.net/