MBM29DL164BE Fujitsu Media Devices, MBM29DL164BE Datasheet - Page 20

• Manufacturer Part Number: MBM29DL164BE
• Description: (MBM29DL16xTE/BE) 16M (2MX8/1MX16) BIT Dual Operation
• Manufacturer: Fujitsu Media Devices

20
MBM29DL16XTE/BE
FUNCTIONAL DESCRIPTION
• Simultaneous Operation
MBM29DL16XTE/BE have feature, which is capability of reading data from one bank of memory while a program
or erase operation is in progress in the other bank of memory (simultaneous operation), in addition to the
conventional features (read, program, erase, erase-suspend read, and erase-suspend program). The bank
selection can be selected by bank address (A
The MBM29DL161TE/BE have two banks which contain
The MBM29DL162TE/BE have two banks which contain
The MBM29DL163TE/BE have two banks which contain
The MBM29DL164TE/BE have two banks which contain
The simultaneous operation can not execute multi-function mode in the same bank. Table 10 shows combination
to be possible for simultaneous operation. (Refer to the Figure 11 Bank-to-bank Read/Write Timing Diagram.)
*: An erase operation may also be supended to read from or program to a sector not being erased.
• Read Mode
The MBM29DL16XTE/BE have two control functions which must be satisfied in order to obtain data at the outputs.
CE is the power control and should be used for a device selection. OE is the output control and should be used
to gate data to the output pins if a device is selected.
Address access time (t
access time (t
enable access time is the delay from the falling edge of OE to valid data at the output pins. (Assuming the
addresses have been stable for at least t
power-up, it is necessary to input hardware reset or to change CE pin from “H” or “L”
Bank 1 (8KB
Bank 1 (8KB
Bank 1 (8KB
Bank 1 (8KB
Case
1
2
3
4
5
6
7
CE
) is the delay from stable addresses and stable CE to valid data at the output pins. The output
eight sectors) and Bank 2 (64KB
eight sectors, 64KB
eight sectors, 64KB
eight sectors, 64KB
ACC
) is equal to the delay from stable addresses to valid output data. The chip enable
Autoselect mode
Bank 1 Status
Program mode
Table 10 Simultaneous Operation
Erase mode *
Read mode
Read mode
Read mode
Read mode
ACC
three sectors) and Bank 2 (64KB
seven sectors) and Bank 2 (64KB
fifteen sectors) and Bank 2 (64KB
-70/90/12
-t
OE
15
time.) When reading out a data without changing addresses after
to A
19
) with zero latency.
thirty-one sectors).
twenty eight sectors).
twenty four sectors).
sixteen sectors).
Autoselect mode
Bank 2 Status
Program mode
Erase mode *
Read mode
Read mode
Read mode
Read mode