rfp-40-100re-s Anaren Microwave, rfp-40-100re-s Datasheet - Page 2

• Manufacturer Part Number: rfp-40-100re-s
• Description: Full Flanged Resistors 40 Watts 100 Ohms
• Manufacturer: Anaren Microwave

Model RFP-40-100RE-S
Typical Performance:
Power De-rating:
Mounting Footprint and Procedure:
USA/Canada:
(2 PLACES)
.025 MIN.
Toll Free:
BOARD LOWER
THAN LEAD.
Europe:
SUGGESTED STRESS RELIEF METHODS
SCALE: NONE
[phone]
[phone]
BOARD EVEN
WITH LEAD.
[phone]
BOARD LOWER
THAN LEAD.
NOT RECOMMENDED APPLICATION
Reel For Pick and Place
SCALE: NONE
Available on Tape and
Manufacturing.
BOARD HIGHER
THAN LEAD.
1.
2.
3.
4.
5.
MAKE SURE THAT THE DEVICES ARE MOUNTED ON
FLAT SURFACES (.001" UNDER THE DEVICE) TO
OPTIMIZE THE HEAT TRANSFER.
DRILL & TAP THE HEATSINK FOR THE APPROPRIATE
THREAD SIZE TO BE USED.
COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH
QUALITY SILICONE GREASE (.001" MAX. THICKNESS).
POSITION DEVICE ON MOUNTING SURFACE & SECURE
USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER.
TORQUE SCREWS TO THE APPROPRIATE VALUE. MAKE
SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK.
(CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF
THE LEADS TOWARDS THE LID).
SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH
A CONTROLLED TEMPERATURE IRON.
SUGGESTED MOUNTING PROCEDURES:
** FOR MORE DETAILS CONTACT FACTORY **
40-100RE-S (097) Rev B