ds26504 Maxim Integrated Products, Inc., ds26504 Datasheet - Page 25
![no-image](/images/no-image-200.jpg)
ds26504
Manufacturer Part Number
ds26504
Description
Ds26504 T1/e1/j1/64kcc Bits Element
Manufacturer
Maxim Integrated Products, Inc.
Datasheet
1.DS26504.pdf
(128 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ds26504L+
Manufacturer:
DALLAS
Quantity:
20 000
Company:
Part Number:
ds26504LN+T&R
Manufacturer:
Maxim Integrated
Quantity:
10 000
Company:
Part Number:
ds26504LNB2+
Manufacturer:
Maxim Integrated
Quantity:
10 000
6. HARDWARE CONTROLLER INTERFACE
In Hardware Controller mode, the parallel and serial port pins are reconfigured to provide direct access to
certain functions in the port. Only a subset of the device’s functionality is available in hardware mode.
Each register description throughout the data sheet indicates the functions that may be controlled in
hardware mode and several alarm indicators that are available in both hardware and processor mode.
Also indicated are the fixed states of the functions not controllable in hardware mode.
6.1 Transmit Clock Source
Refer to
CLOCK is selected by the TCSS0 and TCSS1 pins, as shown in
the same signal as select for TX CLOCK. If the user wants to slave the transmitter to the recovered
clock, then the RCLK pin must be tied to the TCLK pin externally.
Table 6-1. Transmit Clock Source
6.2 Internal Termination
In Hardware Controller mode, the internal termination is automatically set according to the receive or
transmit mode selected. It can be disabled via the TITD and RITD pins. If internal termination is enabled
in E1 mode, the E1TS pin is use to select 75Ω or 120Ω termination. The E1TS pin applies to both
transmit and receive.
Table 6-2. Internal Termination
TCSS1
PIN 31
TITD
PIN 5
RITD
PIN 6
PIN 9
E1TS
0
0
1
1
PIN
Figure
TCSS0
PIN 63
Transmit Internal Termination Disable. Disables the internal transmit termination.
The internal transmit termination value is dependent on the state of the TMODEx pins.
Receive Internal Termination Disable. Disables the internal receive termination. The
internal receive termination value is dependent on the state of the RMODEx pins.
E1 Termination Select. Selects 120Ω or 75Ω internal termination when one of the E1
modes is selected and internal termination is enabled. If E1 is selected for both transmit
and receive, then both terminations will be the same.
0
1
0
1
3-3. In Hardware Controller mode, the input to the TX PLL is always TCLK PIN. TX
0 = internal transmit termination enabled
1 = internal transmit termination disabled
0 = internal receive termination enabled
1 = internal receive termination disabled
0 = 75Ω
1 = 120Ω
The TCLK pin is the source of transmit clock.
The PLL_CLK is the source of transmit clock.
The scaled signal present at MCLK as the transmit
clock.
The signal present at RCLK is the transmit clock.
TRANSMIT CLOCK SOURCE
25 of 128
FUNCTION
Table
6-1. The PLL_OUT pin is always