sa1e-tan2c IDEC Corporation, sa1e-tan2c Datasheet - Page 14

• Manufacturer Part Number: sa1e-tan2c
• Description: Sa1e Miniature Photoelectric Switches
• Manufacturer: IDEC Corporation

SA1E Miniature Photoelectric Switches (Built-in Amplifier Type)
Dimensions
• • • • Reflector Mounting Bracket
IAC-L2 (for IAC-R5)
• • • • Connector Cable (connector on one end)
• Air Blower Mounting Block
14
Straight Type (SA9Z-CM8K-4S
• Dielectric strength when installed on the SA1E: 1000V AC (between live part and mounting bracket, except between live part and tightening ring)
SA9Z-A02
(Material: Anodized aluminum surface)
Material: SPCC (zinc chromate plating, black)
6.9
14.0
25.0
➃ Black
➂ Blue
Cable length: 2 or 5m
M5
42
30
58
P0.8
Recommended mounting
bracket (SA9Z-K01)
➁ White
➀ Brown
6
4-ø4.4
2-ø3.4
M5
P0.8
With Mounting Bracket
(3.2)
)
ø5.2
ø9.6
6.5
IAC-L3 (for IAC-R6)
8-M3 × 0.5 holes
Air Blower
Mounting Block
SA1E-∗∗∗∗
Material: SPCC (zinc plating)
3.5
25
35
25
4.5
19.5
Right-angle Type (SA9Z-CM8K-4L
➃ Black
➂ Blue
20
2.0
Air supply port
Plugging screws
for air supply port
(M5), Gasket
(used on one
side only)
➁ White
➀ Brown
IAC-L5 (for IAC-R8)
Cable length:
2 or 5m
Material: SPCC (zinc plating)
• The SA9Z-A02 air blower mounting
• An air tube fitting (M5) can be
• The air tube fitting and mounting
block is supplied with two mounting
screws (M3 × 20 mm sems screws),
one screw for plugging the air supply
port (M5 × 6 mm), and one gasket for
plugging the air supply port.
installed to either the top or side.
Tighten the fitting to a torque of 0.5
N·m maximum.
bracket are not supplied and must be
ordered separately (recommended
mounting bracket: SA9Z-K01).
(28)
40
50
40
26
16.5
All dimensions are in mm.
ø5.2
)
4.5
8-M3 × 0.7 holes
20
(07/03/06)