t18xsd1eq Banner Engineering Corp., t18xsd1eq Datasheet - Page 4

• Manufacturer Part Number: t18xsd1eq
• Manufacturer: Banner Engineering Corp.

page
Supply Voltage and Current
Output Protection Circuitry
Output Response Time
Repeatability
Indicators
Construction
Environmental Rating
Connections
Operating Conditions
Vibration and
Mechanical Shock
(Supplied)
Supply Protection Circuitry
M18 x 1
Thread
Jam Nut
4
ø 15 mm
(0.59")
T18XSD Series
(All models except emitter)
30.0 mm
Sensitivity Control
(1.18")
T18XSD
(D & L Models)
Power"dicator
Output"dicator
Single Turn
Green LED
Yellow LED
11 to 25V dc (10% maximum ripple); Supply current (exclusive of load current):
Opposed-Mode Emitter: 25 mA
Opposed-Mode Receiver: 45 mA
Polarized & Non-polarized Retro: 55 mA
Diffuse: 55 mA
Fixed-field: 60 mA
Protected against reverse polarity and transient voltages
Protected against false pulse on power-up and continuous overload or short-circuit of outputs
Opposed: 3.5 milliseconds ON and 2.0 milliseconds OFF
Polarized Retro and Fixed-field: 3.5 milliseconds ON and OFF
NOTE: 100 millisecond delay on power-up; outputs do not conduct during this time
Opposed: 575 microseconds
Polarized Retro and Fixed-field: 950 microseconds
Repeatability and response are independent of signal strength
Two LEDs: One Green LED and one Yellow LED
Housings are PBT thermoplastic polyester; Lenses are Lexan
models) T18XSD comes with one jam nut
Leakproof design rated NEMA 6P; IEC IP67
4-pin Euro-style SDS compatible quick-disconnect fitting; cables are ordered separately - interlinkBT
Operating temperature: -25° to +70°C (-13° to +158°F)
Maximum relative humidity: 90% at 50°C (non-condensing)
All models meet Mil. Std. 202F requirements. Method 201A (Vibration; frequency 10 to 60 Hz, max.,
double amplitude 0.06-inch acceleration 10G). Method 213B conditions H&I (Shock: 75G with unit
operating; 100G for non-operation)
11.5 mm
(0.45")
ø 40.0 mm
Green LED: indicates Power to the sensor
Yellow LED: indicates the sensor signal
Yellow LED glowing steady: normally open output is conducting
Yellow LED flashing: excess gain marginal (1-1.5x) in light condition
(1.57")
T18XSD Series Specifications
Dimensions and Features
66.5 mm
(2.62")
(Supplied)
M18 x 1
Thread
Jam Nut
ø 15 mm
(0.59")
Banner Engineering Corp. • Minneapolis, U.S.A.
Website: http://www.baneng.com • Tel: [phone]
®
(opposed models) or acrylic (retro and fixed-field
T18XSD Emitter
30.0 mm
(1.18")
Power"dicator
Green LED
11.5 mm
ø 30.0 mm
(0.45")
(1.18")
56.6 mm
(2.23")