d121xl6 AZ Displays, Inc, d121xl6 Datasheet - Page 20

• Manufacturer Part Number: d121xl6
• Description: Tft-lcd Module
• Manufacturer: AZ Displays, Inc

15. Handling Cautions
15-1) Mounting of module
15-2) Precautions in mounting
15-3) Adjusting module
15-4) Others
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be
distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,
Ltd.
a) Please power off the module when you connect the input/output connector.
b) Polarizer which is made of soft material and susceptible to flaw must be handled carefully.
c) Protective film (Laminator) is applied on surface to protect it against scratches and dirt.
d) Please following the tear off direction as figure 15-1 to remove the protective film as slowly
a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled, wipe it with
b) Wipe off water drops or finger grease immediately. Long contact with water may cause
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped on hard
d) Since CMOS LSI is used in the module. So take care of static electricity and earth yourself
a) Adjusting volumes on the rear face of the module have been set optimally before shipment.
b) Therefore, do not change any adjusted values. If adjusted values are changed, the
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many hours.
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage because of
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.
e) Observe all other precautionary requirements in handling general electronic components.
f) Please adjust the voltage of common electrode as material of attachment by 1 module.
as possible, so that electrostatic charge can be minimized.
soft dry cloth.
specifications described may not be satisfied.
leakage current from approach conductor by to draw lump read lead line around.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet.
Wash it out immediately with soap.
discoloration or spots.
surface. Please handle with care.
when handling.
Figure 15-1 the way to peel off protective film
Page:20
PD121XL6
P-511-596(V:1)