ltl-1che-0b2 LiteOn Technology Corp., ltl-1che-0b2 Datasheet - Page 8

• Manufacturer Part Number: ltl-1che-0b2
• Description: Thru-hole Led Lamps 3mm Round Allngap/gap/gaasp Red Ltl-1che-0b2
• Manufacturer: LiteOn Technology Corp.

6. Drive Method
7. ESD (Electrostatic Discharge)
BNS-OD-C131/A4
Part No. : LTL-1CHE-0B2
Suggestions to prevent ESD damage:
ESD-damaged Leeds will exhibit abnormal characteristics such as high reverse leakage current, low
forward voltage, or “no light up” at low currents. To verify for ESD damage, check for “light up” and
Vf of the suspect LEDs at low currents.
Static Electricity or power surge will damage the LED.
The Vf of “good” LEDs should be >2.0V@0.1mA for InGaN product and >1.4V@0.1mA for AlInGaP product.
connected in parallel in an application, it is recommended that a current limiting resistor be
incorporated in the drive circuit, in series with each LED as shown in Circuit A below.
An LED is a current-operated device. In order to ensure intensity uniformity on multiple LEDs
(B) The brightness of each LED might appear different due to the differences in the I-V characteristics
(A) Recommended circuit
Use a conductive wrist band or anti- electrostatic glove when handling these LEDs
All devices, equipment, and machinery must be properly grounded
Work tables, storage racks, etc. should be properly grounded
plastic lens as a result of friction between LEDs during storage and handing
Use ion blower to neutralize the static charge which might have built up on surface of the LEDs
of those LEDs
InGaN / Sapphire
AlInGaP
InGaN / SiC
Circuit model A
Chip ESD level
LED
LITE-ON TECHNOLOGY CORPORATION
P r o p e r t y o f L i t e - O n O n l y
Machine Model
100 V
200 V
600 V
Circuit model B
LED
Human Body Model
1000 V
300 V
500 V
Page :
8
of
10