6n140a-883b-600 Avago Technologies, 6n140a-883b-600 Datasheet - Page 9

• Manufacturer Part Number: 6n140a-883b-600
• Description: Hermetically Sealed, Low If, Wide Vcc, High Gain Optocouplers
• Manufacturer: Avago Technologies

9
Notes:
10. CM
1. GND Pin should be the most negative voltage at the detector side.
2. Output power is collector output power plus total supply power
3. Derate I
4. Each channel.
5. CURRENT TRANSFER RATIO is defined as the ratio of output collector
6. I
7. All devices are considered two-terminal devices; measured
8. Measured between each input pair shorted together and all output
9. Measured between adjacent input pairs shorted together for each
Keeping V
lowest total I
for the single channel device. For the dual channel device, output
power is collector output power plus one half the total supply
power. For the quad channel device, output power is collector
output power plus one fourth of total supply power. Derate at 1.66
mW/ C above 110 C.
current, I
optical crosstalk. I
channels, I
between all input leads or terminals shorted together and all
output leads or terminals shorted together.
connections for that channel shorted together.
multi-channel device.
can be sustained with the output voltage in the logic low state
(V
voltage that can be sustained with the output voltage in the logic
high state (V
OHX
O
L
< 0.8 V). CM
is the maximum rate of rise of the common mode voltage that
is the leakage current resulting from channel to channel
F
O
at 0.33 mA/ C above 110 C.
CC
, to the forward LED input current, I
F
= 10 mA.
as low as possible, but greater than 2.0 V, will provide
O
OH
> 2.0 V).
H
over temperature.
is the maximum rate of fall of the common mode
F
= 2 A for channel under test. For all other
F
, times 100%.
11. In applications where dV/dt may exceed 50,000 V/ s (such as a
12. This is a momentary withstand test, not an operating condition.
13. Standard parts receive 100% testing at 25 C (Subgroups 1 and 9).
14. Parameters tested as part of device initial characterization and
15. The HCPL-6730, HCPL-6731, and HCPL-673K dual channel parts
16. Not required for 6N140A, 6N140A/883B, HCPL-177K, HCPL-6750/
17. Required for 6N140A, 6N140A/883B, HCPL-177K, HCPL-6750/51/
static discharge) a series resistor, R
protect the detector ICs from destructively high surge currents.
The recommended value is:
R
for single channel;
R
for dual channel;
R
for quad channel.
SMD and 883B parts receive 100% testing at 25,125, and -55 C
(Subgroups 1 and 9, 2 and 10, 3 and 11, respectively).
after design and process changes. Parameters guaranteed to limits
specified for all lots not specifically tested.
function as two independent single channel units. Use the single
channel parameter limits.
51/5K, 8302401, and 5962-9800201 types.
5K, 8302401, and 5962-9800201 types.
CC
CC
CC
= ——––––––– k
= ——––––––– k
= —–––––—–– k
0.15 I
0.3 I
0.6 I
1 (V)
1 (V)
1 (V)
F
F
F
(mA)
(mA)
(mA)
CC
, should be included to