adns-2080-lg Avago Technologies, adns-2080-lg Datasheet - Page 6
![no-image](/images/manufacturer_photos/0/0/85/avago_technologies_sml.jpg)
adns-2080-lg
Manufacturer Part Number
adns-2080-lg
Description
Low Power Optical Mouse Sensor
Manufacturer
Avago Technologies
Datasheet
1.ADNS-2080-LG.pdf
(31 pages)
Important Note: IR LED is recommended for lower power consumption.
Figure 6. Exploded View of Assembly
PCB Assembly Considerations
1. Insert the sensor and all other electrical components
2. Insert the LED into the assembly clip and bend the
3. Insert the LED clip assembly into PCB.
4. Wave solder the entire assembly in a no-wash solder
5. Place the lens onto the base plate.
6. Remove the protective Kapton tape from optical
7. Insert PCB assembly over the lens onto the base plate
6
into PCB.
leads 90 degrees.
process utilizing solder fixture. The solder fixture is
needed to protect the sensor during the solder process.
It also sets the correct sensor-to-PCB distance as the
lead shoulders do not normally rest on the PCB surface.
The fixture should be designed to expose the sensor
leads to solder while shielding the optical aperture
from direct solder contact.
aperture of the sensor. Care must be taken to keep
contaminants from entering the aperture. Recommend
not to place the PCB facing up during the entire mouse
assembly process. Recommend to hold the PCB first
vertically for the Kapton removal process.
aligning post to retain PCB assembly. The sensor
aperture ring should self-align to the lens.
LED
LED Clip
ADNS-2080 (Sensor)
Customer supplied PCB
ADNS-5110-001
Customer supplied base plate with
recommended alignment features
per IGES drawing
8. The optical position reference for the PCB is set by the
9. Install mouse top case. There MUST be a feature in
Figure 7. Block diagram of ADNS-2080 optical mouse
VDDIO
VDDA
GND
VDD
LED
base plate and lens. Note that the PCB motion due to
button presses must be minimized to maintain optical
alignment.
the top case to press down onto the PCB assembly to
ensure all components are interlocked to the correct
vertical height.
ADNS-2080
IMAGE ARRAY
OSCILLATOR
DSP
SDIO
SCLK
MOTION