as13bb Nihon Kaiheiki Industry Co. Ltd., as13bb Datasheet - Page 2

• Manufacturer Part Number: as13bb
• Description: Subminiature Slides Switch
• Manufacturer: Nihon Kaiheiki Industry Co. Ltd.

General Specifications
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com
Electrical Capacity (Resistive Load)
Other Ratings
Materials & Finishes
Environmental Data
PCB Processing
Standards & Certifications
Operating Temperature Range:
Nominal Operating Force:
Insulation Resistance:
Upper Case Housing:
Lower Case Housing:
or CSA Certification:
Stationary Contacts:
Contact Resistance:
Dielectric Strength:
Movable Contact:
Support Bracket:
Mechanical Life:
Contact Timing:
UL Recognition
Electrical Life:
Logic Level:
Soldering:
Terminals:
Vibration:
Humidity:
Cleaning:
Actuator:
Travel:
Shock:
0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: Find additional explanation of operating range in Supplement section.
50 milliohms maximum
500 megohms minimum @ 500V DC
500V AC minimum for 1 minute minimum
50,000 operations minimum
50,000 operations minimum
2.55N
Nonshorting (break-before-make)
Pretravel: .082” (2.1mm); Overtravel: .016” (0.4mm); Total Travel: .098” (2.5mm)
Glass fiber reinforced polyamide
Carbon blended polyacetal (antistatic)
Glass fiber reinforced polyamide
Tin plated phosphor bronze
Phosphor bronze with gold plating
Brass with gold plating
Brass with gold plating
–30°C through +85°C (–22°F through +185°F)
90 ~ 95% humidity for 192 hours @ 40°C (104°F)
10 ~ 60Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 5 minutes; 3 right angled directions for 30 minutes
50G (490m/s
Wave Soldering Recommended. See Profile A in Supplement section.
Manual Soldering: for single pole see Profile B in Supplement section; for double pole see Profile A.
These devices are not process sealed. Hand clean locally using alcohol based solution.
The A Series slides have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Subminiature Slides
Series AS
03-07